Recipe:

1- A piece of plexiglass, or whatever material you wish to use

2- Some screws and spacers

3- 4 sylicone feets (also rubber is good)

4- Some tools, a dremel is suggested.

I started cutting 2 identical pieces of plexiglass with the dremel, the measure 10 x 7 cm approx. To get the borders pretty smooth I used some glass-paper.  Then I made some holes in the corners, and two smaller holes where the Raspberry mounting holes are:

Now, let’s bond the Pi to the lower part of our case, and attach the screws:

Then, add your rubber feets ( I definetely suggest to use them, in order to make your Pi more stable on your desk\table\floor).

Et voilà, put the screws and the spacers, and you’re done!

This is mine, for comparison some healthy goods and the tiny ODAC. Joyful.

Really nothing special. But it’s easy to do, it’s pretty good looking and allows you to attach every peripheral you wish to the Pi.

DIY strikes again.

L'articolo A simple and good looking case for our Raspberry sembra essere il primo su RaspyFi.