Had to downgrade the firmware though
sudo rpi-update 5ea0f44b673eaa52c578fcd6480495f19cd53d97

sudo rpi-update 5ea0f44b673eaa52c578fcd6480495f19cd53d97

http://www.raspyfi.com/forum/c.....t-working/

I tried it again with the firmware-atheros installed but no module for the wlan stick was started.

Maybe I could try a modprobe ath9k_htc. I will tell you what happens.

Tobbes

Connect via SSH

type

sudo apt-get update

and then

sudo apt-get install firmware-atheros

Reboot and retry the configuration, let me know!

the static eth0 does also not work for me.

There is no module loaded for the atheros chip (ath9k_htc).

So there is no wifi possible at the moment with raspyFi 1.0?

Tobbes

SSID, Security (no security) and password (no password) were set but i can not have WIFI to coonect to my WIFI Access Point !

Any Idea ?

Pinpon

admin said

Try to configure static ethernet ip, and see if wlan interfaces are shown

this worked for me. (connected to the specified SSID)

it also does not work for me.

No wlan devices were found (both are working on raspyfi beta before).

LogiLink WL-0049A
TP-Link TL-WN721N

Please give a hint!
Tobbes

I also just downloaded RaspyFi V1.0.
Nice job !
But I encoutered some problems :

1- Connexion on NAS is not reliable. I have to try many times to configure NAS connexion on WebUI and it often remains with a red cross ! I could only connect to NAS 2 times.
2- Once connected to NAS (Synology DS409+ v4.2) I can access database and play music but there are some glitches sometimes (not very often). I use a Lavry DA11 DAC through USB.
You can put in the supported DAC section that this DAC works with 24 bits 96Khz files but I can't check if the sampling rate and bit depth are converted or not (bitperfect) by the Raspberry Pi. Hardware mix doesn't seem to work. How can I reliably check those functions ?
3- I can't have the WIFI Dongle set up ! I know my dongle (TRENDNET TEW-648UBM) works with Raspbmc (already checked) but when I try to set it up with RaspyFi WebUI nothing works (no IP address attributed to WIFI only get one to ETHERNET connexion).

Any ideas to help me get rid of those issues ?

Many thanks in advance and congratulations for this marvelous work !!!
Really !

Pinpon

2 issues so far. I'm connected through ethernet and (trying to) wifi.
1) NAS doesnt mount. On my windows machine it's on 192.168.2.1/volume1. All I get is a red cross. it's large, but I dont see any progress indicator for anything that could be going on.

2) Wifi still doesnt work. I tried entering the SSID, encryption and password, but nothing happens when I click save changes.

Any ideas?
cheers

Any idea?

Thanks!

S.